[Paraview] Problems with ParaView 3.6.2 and VTKEdge

[Zhanping Liu]

agagliardi:

If you are using Windows, then

(1) open a DOS cmd window
(2) go to ParaView_Build\bin\debug\
(3) set PATH=%PATH%;VTKEdge_Build\bin\debug
(4) paraview

I once encountered a similar problem. After including the VTKEdge dir to
PATH, it then worked properly.

-Zhanping
-- 
Zhanping Liu, PhD
Kitware, Inc.
28 Corporate Drive
Clifton Park, NY 12065-8662
Phone: 518-371-3971 x 138
http://www.zhanpingliu.org

On Tue, Jan 12, 2010 at 11:01 AM, Adriano Gagliardi <agagliardi at ara.co.uk>wrote:

> Dear All,
>
> I've recently updated to the release version of ParaView 3.6.2. I've
> managed
> to compile VTKEdge again, but anytime I have it loaded and attempt to load
> a
> data file I get a segmentation fault. ParaView works fine when it isn't
> loaded. It appears as though it is crashing out after all data has been
> read
> in and it is about to display to screen. I've tried to force it to display
> an outline representation initially, but it still crashes.
>
> Has anyone else had this problem?
>
> Regards,
>
> Adriano
>
> ===================================
>
> Adriano Gagliardi MEng PhD
> Project Scientist
> Computational Aerodynamics
> Aircraft Research Association Ltd.
> Manton Lane
> Bedford
>
> Tel: 01234 32 4644
> E-mail: agagliardi at ara.co.uk
> Url: www.ara.co.uk
>
>
> ---------------------------
> This email contains information that is private and confidential and is
> intended only for the addressee.  If you are not the intended recipient
> please delete it and notify us immediately by e-mailing the sender.
> Note: All email sent to or from this address may be accessed by someone
> other than the recipient, for system management and security reasons.
> Aircraft Research Association Ltd.  Registered in England, Registration No
> 503668 Registered Office: Manton Lane, Bedford MK41 7PF England VAT No GB
> 196351245
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20100112/56870cde/attachment.htm>