[Paraview] QT_HELP_GENERATOR-NOTFOUND

[Utkarsh Ayachit]

What version of Qt are you using? Ensure that QT_HELP_GENERATOR is set
to the qhelpgenerator executable.

Utkarsh

On Thu, Jan 7, 2010 at 7:44 AM, Robert Sawko <R.Sawko at cranfield.ac.uk> wrote:
> Dear All,
>
> I am trying to run compile ParaView on 64 bit openSUSE 11.2 with KDE
> 4.3.1. I was using this website as a reference
> http://www.cmake.org/Wiki/ParaView:Build_And_Install. Unfortunately
> after configuring the installation with ccmake I get
> QT_HELP_GENERATOR-NOTFOUND in QT_HELP_GENERATOR variable. Executing
> make ends up with an error:
>
> [ 99%] Built target H5PartReader
> [ 99%] Compiling Qt help project paraview.qhp
> /bin/sh: QT_HELP_GENERATOR-NOTFOUND: command not found
> make[2]: *** [Documentation/CMakeFiles/ParaViewOnlineHelp] Error 127
> make[1]: *** [Documentation/CMakeFiles/ParaViewOnlineHelp.dir/all] Error 2
>
> Could you let me know if you had any hints as to solve this problem? I
> would be very much obliged for any assistance.
>
> Kind regards,
> Robert
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>