[Paraview] XY Plot question
Eric Allison
eallison at desktopaero.com
Fri Oct 30 15:28:30 EDT 2009
Thanks for your replies. This example (from ensight) is somewhat ugly,
but indicative of what I am after:
http://legacy.ensight.com/products/cpplot.html
-eric
On Oct 30, 2009, at 11:29 AM, Marcus D. Hanwell wrote:
> On Friday 30 October 2009 14:18:03 Moreland, Kenneth wrote:
>> Uh... I don't think any of us have thought of that particular plot
>> configuration. Someone at Kitware should make sure that this design
>> consideration filters its way to Marcus.
>>
>> -Ken
>>
>>
>> On 10/28/09 10:31 PM, "Eric Allison" <eallison at desktopaero.com>
>> wrote:
>>
>> Apologies if this is a dumb question - I'm investigating Paraview
>> as a
>> replacement for Tecplot, and one of the things I'd really like to do
>> is take Cp slices on CFD geometries. I figured out how to make an XY
>> plot of the slice data, but can't for the life of me figure out how
>> to
>> reverse the Y axis so that Cp displays the way aero people like to
>> see
>> it. (smaller numbers at the top, larger at the bottom).
>>
>> Any help would be appreciated.
>
> I saw the message, what I am doing should be able to accommodate
> this type of
> layout, I will test this out later just to confirm. So something
> akin to
> setting the minimum Y value to 5.0 and the maximum Y value to 0.0?
>
> Any example plots you may be able to point out would help me.
>
> Marcus
> --
> Marcus D. Hanwell, Ph.D.
> R&D Engineer, Kitware Inc.
> (518) 881-4937
More information about the ParaView
mailing list