[Paraview] integrate flow over line

[Moreland, Kenneth]

All coordinates in VTK/ParaView are in R^3.  However, if you define your data in the x-y plane (that is, z == 0 for all coordinates) then Surface Flow should give you the correct answer.

-Ken


On 11/26/09 10:31 AM, "Martijn" <martijn.brouwer at inter.nl.net> wrote:

Hi,
This week I discovered ParaView and I am impressed (and a little
intimidated) by its possibilities.
A question: is a 2D equivalent of the "Surface Flow" filter? I have a
small 2D thermal simulation and would like to caluclated the flow over a
boundary: int (dT/dx, dT/dy)*n dl.

with kind regards,

Martijn

_______________________________________________
Powered by www.kitware.com

Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html

Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView

Follow this link to subscribe/unsubscribe:
http://www.paraview.org/mailman/listinfo/paraview




   ****      Kenneth Moreland
    ***      Sandia National Laboratories
***********
*** *** ***  email: kmorel at sandia.gov
**  ***  **  phone: (505) 844-8919
    ***      web:   http://www.cs.unm.edu/~kmorel

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20091130/7efdd142/attachment.htm>