[Paraview] limiting streamlines in paraview

[Bastil2001 at yahoo.de]

At least I am interested in this.
In general streamlines are better in 3.7dev, stream tracer has obviously
improved. However generating constrained streamlines with emitters on
one part of a multi-block dataset streamlines often terminate at the
border to another part - reason for termination ist "6" - any suggestions?

Regards BastiL

Berk Geveci schrieb:
> I am not sure I understand. You are interested in surface constrained
> streamlines? I am guessing from an inviscid simulation?
>
> -berk
>
> On Wed, Jun 3, 2009 at 4:50 AM, Luc Bordier <luc.bordier at sirehna.com> wrote:
>   
>> Hello,
>>
>> Is it possible to compute limiting streamlines in paraview (for exemple on a
>> vessel hull) ?
>>
>> Thanks to anyone who have the answer.
>>
>> --
>> _________________________
>> Luc Bordier
>> R&D Engineer
>> luc.bordier at sirehna.com
>> http://www.sirehna.com
>> SIREHNA
>> 1, rue de la Noe
>> BP 42105
>> 44321 NANTES CEDEX 3
>> FRANCE
>> Tel: +33 2 51 86 02 80
>> Fax: +33 2 40 74 17 36
>> _________________________
>>
>> _______________________________________________
>> Powered by www.kitware.com
>>
>> Visit other Kitware open-source projects at
>> http://www.kitware.com/opensource/opensource.html
>>
>> Please keep messages on-topic and check the ParaView Wiki at:
>> http://paraview.org/Wiki/ParaView
>>
>> Follow this link to subscribe/unsubscribe:
>> http://www.paraview.org/mailman/listinfo/paraview
>>
>>     
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>
>