[Paraview] Block selection

[Berk Geveci]

Yes it is possible, with a lot of effort. I would wait until 3.4. It
will have this feature.

-berk

On 1/21/08, Edwards, Paul <Paul.Edwards3 at rolls-royce.com> wrote:
>
> Is it possible to write a plugin that could select a block in a multi block structured mesh (in the same way that you can select blocks)?  Any advice on this would be appreciated.
>
> Regards,
> Paul
>
> The data contained in, or attached to, this e-mail, may contain confidential information. If you have received it in error you should notify the sender immediately by reply e-mail, delete the message from your system and contact +44 (0) 1332 242424 (the Rolls-Royce IT Security Director) if you need assistance. Please do not copy it for any purpose, or disclose its contents to any other person.
>
> An e-mail response to this address may be subject to interception or monitoring for operational reasons or for lawful business practices.
>
> (c) 2008 Rolls-Royce plc
>
> Registered office: 65 Buckingham Gate, London SW1E 6AT Company number: 1003142. Registered in England.
> _______________________________________________
> ParaView mailing list
> ParaView at paraview.org
> http://www.paraview.org/mailman/listinfo/paraview
>