[Paraview] plot over line

[Berk Geveci]

Question: If I implemented the ability to plot values along a closed
curve, where should the plot start?

-berk

On Tue, Nov 25, 2008 at 4:38 AM, Stephen Wornom
<stephen.wornom at sophia.inria.fr> wrote:
> Berk Geveci wrote:
>>
>> Hi Stephen,
>>
>> This is a feature we are looking at implementing for the next release.
>> Just a question though, how did you generate the line?
>>
>
> extract surface -> connectivity filter -> threshold filter + slice in z
> Stephen
>>
>> -berk
>>
>> On Thu, Nov 20, 2008 at 5:29 AM, Stephen Wornom
>> <stephen.wornom at sophia.inria.fr> wrote:
>>
>>>
>>> How does one "plot over line" if the line is curved in x,y,z?
>>> I would like to plot pressure over a curved line in a x-y plane.
>>>
>>> I tried:
>>> 1-using the calculator to compute the arc length but the plot options
>>> remain
>>> lines in x or y or z (no arc length is added).
>>> 2-I tried exporting, I get the x,y, z coordinates to process outside of
>>> PV
>>> but the pressure does not get written.
>>> Any ideas?
>>> Stephen
>>>
>>> --
>>> stephen.wornom at sophia.inria.fr
>>> 2004 route des lucioles - BP93
>>> Sophia Antipolis
>>> 06902 CEDEX
>>>
>>> Tel: 04 92 38 50 54
>>> Fax: 04 97 15 53 51
>>>
>>>
>>> _______________________________________________
>>> ParaView mailing list
>>> ParaView at paraview.org
>>> http://www.paraview.org/mailman/listinfo/paraview
>>>
>>>
>>>
>>
>> _______________________________________________
>> ParaView mailing list
>> ParaView at paraview.org
>> http://www.paraview.org/mailman/listinfo/paraview
>>
>
>
> --
> stephen.wornom at sophia.inria.fr
> 2004 route des lucioles - BP93
> Sophia Antipolis
> 06902 CEDEX
>
> Tel: 04 92 38 50 54
> Fax: 04 97 15 53 51
>
>