[Paraview] comparing z= constant planes

[Moreland, Kenneth]

You can translate the output of the slice filter in the Z direction (or any other direction) using the Transform filter.

-Ken


On 11/28/08 8:20 AM, "Stephen Wornom" <stephen.wornom at sophia.inria.fr> wrote:

I have to parallel planes offset by a constant z. I slice twice to get
the two planes, z1 and z2 (z2= z1+ conste).
I would like to overlay the wire frames (remove the z-offset from plane
z2), how does one do this?
Stephen

--
stephen.wornom at sophia.inria.fr
2004 route des lucioles - BP93
Sophia Antipolis
06902 CEDEX

Tel: 04 92 38 50 54
Fax: 04 97 15 53 51




   ****      Kenneth Moreland
    ***      Sandia National Laboratories
***********
*** *** ***  email: kmorel at sandia.gov
**  ***  **  phone: (505) 844-8919
    ***      web:   http://www.cs.unm.edu/~kmorel

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20081201/05ca47d7/attachment.htm>