[Paraview] pv 2.6.0: LOD in client server mode

Moreland, Kenneth kmorel at sandia.gov
Thu Mar 1 17:06:17 EST 2007


I observe the same erroneous behavior.  I took the liberty of submitted
a bug report (#4522).

 

http://www.paraview.org/Bug/bug.php?op=show&bugid=4522

 

-Ken

 

________________________________

From: paraview-bounces+kmorel=sandia.gov at paraview.org
[mailto:paraview-bounces+kmorel=sandia.gov at paraview.org] On Behalf Of
joseph insley
Sent: Wednesday, February 28, 2007 1:30 PM
To: paraview at paraview.org
Subject: [Paraview] pv 2.6.0: LOD in client server mode

 

When I run ParaView 2.6.0 in pvclient/pvserver mode the LOD doesn't seem
to kick in until I change the LOD value.  Each time a load a new data
set, or apply a filter to one that is already loaded, it doesn't
automatically switch into LOD mode while interacting.  Once I change the
LOD value I start getting decimated geometry, and it works as expected,
but it initially always does full-res rendering.  This is true even if
the LOD value is set to a low value before the data is loaded; it does
full-res rendering.  When I then increase the LOD value the decimated
geometry is calculated and displayed while interacting.  I don't see
this behavior using the standalone paraview application, only in
pvclient/pvserver mode.

 

Has anyone else run into this problem?

 

Thanks,

joe.

 

===================================================

joseph a. insley
insley at mcs.anl.gov

mathematics & computer science division       (630) 252-5649

argonne national laboratory                               (630) 252-5986
(fax)





 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://public.kitware.com/pipermail/paraview/attachments/20070301/643bdd89/attachment.htm


More information about the ParaView mailing list