[Paraview] polygon offset

[Wylie, Brian]

Okay I know this is a not a 'solution' but for a quick fix set the line
width to '2' instead of '1'. It will look much better. :)

  Brian Wylie - Org 9227
  Sandia National Laboratories
  MS 0822 - Building 880/A1-J
  (505)844-2238 FAX(505)845-0833                       
       ____                  _    __
      / __ \____  _________ | |  / (_)__ _      __ 
     / /_/ / __ `/ ___/ __ `/ | / / / _ \ | /| / /
    / ____/ /_/ / /  / /_/ /| |/ / /  __/ |/ |/ /
   /_/    \__,_/_/   \__,_/ |___/_/\___/|__/|__/

                                    Unleash the Beast
 

> -----Original Message-----
> From: paraview-bounces+bnwylie=sandia.gov at paraview.org 
> [mailto:paraview-bounces+bnwylie=sandia.gov at paraview.org] On 
> Behalf Of Dominik Szczerba
> Sent: Tuesday, December 06, 2005 9:26 AM
> To: paraview at paraview.org
> Subject: [Paraview] polygon offset
> 
> Hello,
> Does Paraview support OpenGL polygon offset extension? If I 
> try to visualize e.g. a tet mesh with edges (extract edges, 
> shrink tets) the result looks very bad. Does VTK offer it at 
> all? Is it at all possible using the VTK's filter philosophy?
> regards,
> Dominik
> --
> Dominik Szczerba, Dr.
> ETZ C110 CO-ME/BIWI CH-8092 Zurich
> http://www.vision.ee.ethz.ch/~domi
> _______________________________________________
> ParaView mailing list
> ParaView at paraview.org
> http://www.paraview.org/mailman/listinfo/paraview
> 
>