[Insight-developers] Dashboard Cleanup : Timeout of Join Series in Dash11.kitware : 1, 722 Streaming WARNING messages

[Luis Ibanez]

Hi Brad

I logged in dash11 to run the test manually and to
figure out what a reasonable time out would be for it.


In doing so, I notice that this test is printing out a
very large amount of text, that probably accounts
for a good fraction of its long execution time.


To be more specific:

The test is printing out about 19,000 lines of text,
most of it is repetitions of the message:

------------------------------------------------------------
492: WARNING: In /home/ibanez/src/Insight/Code/Common/itkImageBase.txx, line 288
492: Image (0x10e6750): Not executing UpdateOutputData due to zero
pixel condition RequestedRegion:ImageRegion (0x10e6890)
492:   Dimension: 2
492:   Index: [0, 0]
492:   Size: [0, 0]
492:  BufferedRegion: ImageRegion (0x10e68b8)
492:   Dimension: 2
492:   Index: [0, 0]
492:   Size: [0, 0]
---------------------------------------------------------------

This same message is printed out 1,722 times     :-(

-

A)   Is that message significant to the test ?

B)   Could we run the test in a smaller image perhaps ?


In its current form the test needs 160 seconds
to run in this machine.

I'm increasing the timeout to 240 seconds,
just to get the test to pass.

but we probably should reconsider the structure
and purpose of this tests.


    Any suggestions ?


         Thanks


             Luis



------------------------------------------
On Wed, Jan 20, 2010 at 8:55 AM, Dave Partyka <dave.partyka at kitware.com> wrote:
> Resending as I wasn't a member of insight-developers.
>
> On Wed, Jan 20, 2010 at 8:42 AM, Dave Partyka <dave.partyka at kitware.com>
> wrote:
>>
>> No objection here if it really takes that long to run. Granted that
>> machine is pretty old/slow.
>>
>> On Wed, Jan 20, 2010 at 8:40 AM, Luis Ibanez <luis.ibanez at kitware.com>
>> wrote:
>>>
>>> The test:
>>>
>>>
>>>          itkJoinSeriesImageFilterStreamingTest
>>>
>>> http://www.cdash.org/CDash/viewTest.php?onlyfailed&buildid=519006
>>>
>>>
>>>            Is timing out in dash11.kitware.
>>>
>>> The current timeout is set to 120 seconds.
>>>
>>> Does anybody has an objection to raising the
>>> TIMEOUT value of dash11  ?
>>>
>>>
>>>   Thanks
>>>
>>>
>>>        Luis
>>
>
>