[Insight-developers] RE: [Cmake] Generating code during the b uild: Fluid FLTK

[Miller, James V (CRD)]

Luis,

Will you be working on this today?  Just wondering whether I need to re-configure the dashboard
builds.

Jim

-----Original Message-----
From: Luis Ibanez [mailto:ibanez@choroid.cs.unc.edu]
Sent: Monday, December 10, 2001 10:45 AM
To: Miller, James V (CRD)
Cc: Franck Bettinger; CMake developers (E-mail); insight-Developers
Subject: Re: [Insight-developers] RE: [Cmake] Generating code during the
build: Fluid FLTK



Jim,

There are some problems in VC++ with
the FLTK_WRAP_GUI command, I'm working
on that.

It is woking ok on Unix though.

Luis


-------------------

On Mon, 10 Dec 2001, Miller, James V (CRD) wrote:

> Luis,
>
> Did you resolve this problem?  I am trying to get the Dashboard builds to run the fluid commands (I
> updated them to fltk-1.0.11).  But when I run cmake, I get this error:
>
> C:\itkQuality\Insight-intel>c:\itkQuality\CMake\Source\cmake ../Insight
> CMake Error: Bad target typeC:/itkQuality/Insight-intel/Examples/Curves2DExtract
> or/ceExtractorConsoleGUI.cxx
> CMake Error: Error Writing C:/itkQuality/Insight-intel/Examples/Curves2DExtracto
> r/C:/itkQuality/Insight-intel/Examples/Curves2DExtractor/ceExtractorConsoleGUI.c
> xx.dsp
> CMake Error: Error Reading
> CMake Error: Error Reading
>
> This looks like the same problem you reported except that my cmake stops at this point and will not
> proceed. Thus, I would say the wrap command is "not" working since I cannot build the rest of my
> project.
>
> Jim
>