[ITK] [ITK-users] Command line use of N4 in MacOS terminal

Erik Olsson Erik.Olsson at neuro.gu.se
Tue Jan 20 15:04:10 EST 2015



Hi,

I have recently started to use N4 as a command line installation and the bias field correction works great in general.

I am trying to figure out how to configure the flags for best performance on our T2 MRI images and when trying the rescale intensities I get the error message "segmentation fault 11" for both options ( -r 1   as well as -r 0). I also have a problem with the convergence flag -c, all works fine when I leave this flag out but when trying for example -c 50x50x50x50,0.0001 it stops after 1 iteration (Current level = 1
  Iteration 1 (of 50).   Current convergence value = 0.000816419 (threshold = 0.001). It does not seem like my specification of the threshold is read but the default value is used. Do you have an example of a typical setting for the -c flag other than the default values?

best regards
Erik

Erik Olsson
PhD

Institute of Psychiatry and Neurochemistry
Department of Neuroscience & physiology
The Sahlgrenska academy
Gothenburg University
Sweden
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://public.kitware.com/pipermail/community/attachments/20150120/ffc9b0f3/attachment-0001.html>
-------------- next part --------------
_____________________________________
Powered by www.kitware.com

Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html

Kitware offers ITK Training Courses, for more information visit:
http://www.kitware.com/products/protraining.php

Please keep messages on-topic and check the ITK FAQ at:
http://www.itk.org/Wiki/ITK_FAQ

Follow this link to subscribe/unsubscribe:
http://public.kitware.com/mailman/listinfo/insight-users


More information about the Community mailing list