[ITK] Running an ITK program

[Med SWEng]

Hi Jon,

Thanks for your instructions.


On Fri, Apr 25, 2014 at 8:25 PM, Jon Haitz Legarreta <
jhlegarreta at vicomtech.org> wrote:

> Hi,
> welcome to ITK.
>
> The ITK wiki [1] and the ITK software guide [2] are both worth the lecture
> to start with ITK.
>
> The easiest way to build ITK is to use CMake [3]. CMake will do all the
> necessary steps to configure and generate the solution or makefiles
> depending on the OS you are using. In CMake you will specify where your
> binaries will be located, so you will just need to point to this location
> when trying to build your own ITK-based application.
>
> HTH,
> JON HAITZ
>
> [1] http://www.itk.org/ItkSoftwareGuide
> [2] http://www.itk.org/Wiki/ITK/Getting_Started
> [3] http://www.cmake.org/
>  <http://www.vicomtech.org/en/proteccion-datos>
>
>
> On 25 April 2014 20:11, Med SWEng <medcompsweng at gmail.com> wrote:
>
>> Hello,
>>
>> I'm new to ITK. If I want to run an ITK program I have created through
>> visual studio, should it be located in the same place where ITK was
>> installed? As I'm getting errors at the place were "itk" is used in the
>> program.
>>
>> Thanks.
>>
>> _______________________________________________
>> Community mailing list
>> Community at itk.org
>> http://public.kitware.com/cgi-bin/mailman/listinfo/community
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://public.kitware.com/pipermail/community/attachments/20140425/43eb5302/attachment-0002.html>