[vtkusers] volume pro 1000 on linux with VTK

[Dr. Daniel James White PhD]

Hi all,

Any one have any tips for installation, setup and use of the volume pro 
1000 volume rendering board on linux with VTK.

do I have to recompile my VTK build from scratch? Or is just compiling 
the volume pro part from CMake enough?

Anything to watch out for?

Are there any other volume pro users out there I could chat to?

I have the 512MB volume pro 1000 board in a short/32 bit pci slot (so 
not all the pins of the 64 bit connector on the board are used)
in a MSI KT3 Ultra ARU mother board. Running red hat linux 8.0, VTK 
from recent CVS.

cheers

Dan


Dr. Daniel James White BSc. (Hons.) PhD
Cell Biology
Department of biological and environmental science
PO Box  35
University of Jyväskylä
Jyväskylä FIN 40014
Finland
+358 (0)14 260 4183 (work)
+358 (0)414740463 (mob)

http://www.chalkie.org.uk
dan at chalkie.org.uk
white at cc.jyu.fi