[Paraview] Bug report: tube diameter in paraview 4.01

[Moreland, Kenneth]

Dieter,

Can you give some steps that cause the problem? I tried changing the
radius in the tube filter and it is working fine for me. Maybe you are
doing something different that I have not tried.

-Ken



On 6/13/14 7:20 AM, "Dieter Froning" <d.froning at fz-juelich.de> wrote:

>I am using paraview 4.1.0 (linux 64 bit).
>
>The diameter of the tube filter is ignored.
>paraview 3.98 is working well.
>--
>mit freundlichen Gruessen / best regards
>
>D i e t e r   F r o n i n g
>
>Institut fuer Energie- und Klimaforschung (IEK)
>IEK-3: Elektrochemische Verfahrenstechnik
>tel.: +49 2461 61-6676
>fax:  +49 2461 61-6695
>e-mail: d.froning at fz-juelich.de
>
>
>
>
>
>
>
>--------------------------------------------------------------------------
>----------------------
>--------------------------------------------------------------------------
>----------------------
>Forschungszentrum Juelich GmbH
>52425 Juelich
>Sitz der Gesellschaft: Juelich
>Eingetragen im Handelsregister des Amtsgerichts Dueren Nr. HR B 3498
>Vorsitzender des Aufsichtsrats: MinDir Dr. Karl Eugen Huthmacher
>Geschaeftsfuehrung: Prof. Dr. Achim Bachem (Vorsitzender),
>Karsten Beneke (stellv. Vorsitzender), Prof. Dr.-Ing. Harald Bolt,
>Prof. Dr. Sebastian M. Schmidt
>--------------------------------------------------------------------------
>----------------------
>--------------------------------------------------------------------------
>----------------------
>
>_______________________________________________
>Powered by www.kitware.com
>
>Visit other Kitware open-source projects at
>http://www.kitware.com/opensource/opensource.html
>
>Please keep messages on-topic and check the ParaView Wiki at:
>http://paraview.org/Wiki/ParaView
>
>Follow this link to subscribe/unsubscribe:
>http://www.paraview.org/mailman/listinfo/paraview