[Paraview] CGNS Reader

Wed Aug 7 15:56:08 EDT 2013

I was afraid you say that!   8-)

So, are there any additional parameters that need to be set, such as where the VisIt libraries are installed, etc?   In the Superbuild, I've looked in the CMakeCache.txt file, and I don't see any additional parameters for the bridge or for cgns.

Is this page still current and correct?   http://www.paraview.org/Wiki/VisIt_Database_Bridge#CGNS_Support

________________________________
Rick Angelini

USArmy Research Laboratory
CISD/HPC Architectures Team
Building 120 Cube 315
Phone:  410-278-6266

________________________________________
From: Utkarsh Ayachit [utkarsh.ayachit at kitware.com]
Sent: Wednesday, August 07, 2013 3:25 PM
To: Angelini, Richard C (Rick) CIV USARMY ARL (US)
Cc: paraview at paraview.org
Subject: Re: [Paraview] CGNS Reader

Rick,

Correct, VisItBridge is required for CGNS support. You can turn on
VisItBridge by using the ENABLE_visitbridge cmake option.

Utkarsh

On Wed, Aug 7, 2013 at 3:05 PM, Angelini, Richard C (Rick) CIV USARMY
ARL (US) <richard.c.angelini.civ at mail.mil> wrote:
> I'm using the Superbuild to build ParaView 4.0.1 .... and I'm enabling CGNS
> but the reader doesn't seem to be there.   I can see that it downloaded at
> cgnslib tarball and it seems to have been built.    I poked around on the
> Wiki and there's also a mention of using the VisIt bridge.     Is the VisIt
> bridge (which I'm not using) the only way to read a CGNS file?
>
>
>
> ________________________________
> Rick Angelini
>
> USArmy Research Laboratory
> CISD/HPC Architectures Team
> Building 120 Cube 315
> Phone:  410-278-6266
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>