[Paraview] visualizing line widths

[Dominik Szczerba]

I found by experimenting, that the filter works only with the nodal
values, whereas I tried cell values before. I am glad with the results,
although it's a bit confusing, as the widths given per cell should be
visualized here as well (constant width over the segment as opposed to
scaling when the nodal values are used).
thanks a lot and regards,
Dominik

Berk Geveci wrote:

>Yes it is, although potentially memory consuming:
>
>* apply extract edges or extract surface
>* apply tube and set "vary radius" to on
>
>On 9/14/05, Dominik Szczerba <domi at vision.ee.ethz.ch> wrote:
>  
>
>>Hello,
>>I am relatively new to paraview. I need to view an unstructured mesh
>>(defined as points+segments) where I want to plot the cells (=segments)
>>with a line width corresponding to their scalar field values. Is that
>>possible?
>>thanks a lot,
>>Dominik
>>
>>--
>>Dominik Szczerba, Dr.
>>ETZ C110 CO-ME/BIWI CH-8092 Zurich
>>http://www.vision.ee.ethz.ch/~domi
>>
>>_______________________________________________
>>ParaView mailing list
>>ParaView at paraview.org
>>http://www.paraview.org/mailman/listinfo/paraview
>>
>>    
>>

-- 
Dominik Szczerba, Dr.
ETZ C110 CO-ME/BIWI CH-8092 Zurich
http://www.vision.ee.ethz.ch/~domi