[Cdash] Does cdash detect changes in a test timing

Bill Lorensen bill.lorensen at gmail.com
Fri Dec 9 16:32:59 UTC 2011


http://www.cdash.org/CDash/testDetails.php?test=118063952&build=1643508

The change occurred around Sept 20 and has increased since then.

On Fri, Dec 9, 2011 at 11:28 AM, David Cole <david.cole at kitware.com> wrote:
> There's also a "Test time # max failures before flag:" setting, which
> is set to 3. Perhaps it needs to fail timing 3 days in a row before
> email is sent?
>
>
> On Fri, Dec 9, 2011 at 11:26 AM, David Cole <david.cole at kitware.com> wrote:
>> There's an "Enable test timing" check box in the project settings, and
>> for "Insight" it is checked at the moment...
>>
>> What test is it that showed this increase? I would think that it would
>> show up as "timing failed" for a 5x increase...
>>
>>
>> On Fri, Dec 9, 2011 at 11:23 AM, Bill Lorensen <bill.lorensen at gmail.com> wrote:
>>> We recently discovered that a change we made in itk caused a test to
>>> increase its time by over a factor of 5. I thought that cdash would
>>> report this. Is there a special setting to enable this?
>>>
>>> Bill
>>>
>>> --
>>> Unpaid intern in BillsBasement at noware dot com
>>> _______________________________________________
>>> Cdash mailing list
>>> Cdash at public.kitware.com
>>> http://public.kitware.com/cgi-bin/mailman/listinfo/cdash



-- 
Unpaid intern in BillsBasement at noware dot com



More information about the CDash mailing list